 |
 |
 |
|
|
|
[Sponsors] | ||||
July 25, 2014, 16:00
|
Solver setting in microfluidics simulation
|
#1 |
|
New Member
Minliang Liu
Join Date: Jul 2014
Posts: 5
Rep Power: 11  |
I am simulating fluid field of a micromixer created by nanomotor. The motor rotate in speed range from 10rad/s to 100 rad/s, speed is sinel, I can simplify it as a constant. I confine the nanorod (300nm in diameter and 10 um in length) in a fluid channel with a width of 20 um and simulate the velocity field. I use the sliding mesh method. The initial condition is "all 0 in all zones", Does it make sense?
I have a question. Which solver model should I use? and what else should I notice about setting up ? |
|
|
|
|
 |
| Tags |
| fluent 14.5, microfluidics, solver options |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Setting a pipe simulation | spacecraft | STAR-CCM+ | 0 | February 21, 2014 19:42 |
| Problem during simulation of mixid fluids ( solver: buoyantBoussinesqSimpleFoam) | Cenzy | OpenFOAM Running, Solving & CFD | 1 | October 19, 2013 17:06 |
| Simulation of a laval nozzle - which solver? | summer_of_69 | OpenFOAM | 0 | August 12, 2013 11:35 |
| flat plate simulation using compressible solver | cfdcoder | Main CFD Forum | 3 | November 2, 2012 10:39 |
| solver for simulate droplet flow in microfluidics | titio | OpenFOAM Running, Solving & CFD | 0 | October 1, 2009 14:02 |
Linear Mode
