|
[Sponsors] |
August 7, 2014, 11:29 |
tie two boundary conditions together
|
#1 |
New Member
Mike
Join Date: Jul 2014
Posts: 4
Rep Power: 11 |
Hello,
Has anyone any experience in tying two boundary conditions together? My problem: I have a model of two separate flow streams within a solid body where they communicate heat. I would like the inlet temperature of the second stream to be equal to the outlet temperature of the first stream (unknown a priori). Can I do this using parameters... or must I use UDF? Thanks, Mike |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
GETVAR Error in Multiband Monte Carlo Radiation Simulation with Directional Source | silvan | CFX | 3 | June 16, 2014 09:49 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
[Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 09:38 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |