|
[Sponsors] |
October 7, 2014, 09:30 |
Cone spray (pressure swirl atomizer)
|
#1 |
New Member
Join Date: Sep 2014
Posts: 1
Rep Power: 0 |
Hi all,
I try to simulate an injection for a stationary oil burner in 2D axisymmetric. Therefore I use the DPM. The fuel is injected by a cone swirl nozzle (45°). I wanted to use the pressure swirl atomizer model for the injection, but don't know how to setup the sheet and ligament constant. As I understand these patameters can be laft as default for high pressure injections. My setup has ~30 bar. Is it recommondated to use this model or shoult I use an injection with group particle stream? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
transient result in spray reactor with swirl flow | glenn creten | Main CFD Forum | 1 | August 14, 2012 05:10 |
pressure swirl atomizer | saurabh diksht | FLUENT | 3 | August 23, 2007 08:02 |
pressure swirl atomizer in 2d Axisymmetric | kev | FLUENT | 0 | December 6, 2005 00:10 |
Solid cone spray | cp | FLUENT | 4 | November 6, 2003 11:19 |
pressure gradient term in low speed flow | Atit Koonsrisuk | Main CFD Forum | 2 | January 10, 2002 10:52 |