Home > Forums > Software User Forums > ANSYS > FLUENT

Volume fraction never goes below the certain value

Mark Forums Read

Reply

Search this Thread

September 18, 2014, 04:20	Volume fraction never goes below the certain value	#1
sirpolar Member Ebrahim Join Date: Feb 2014 Posts: 57 Rep Power: 13	In two phase flow modeling (drainage) by Fluent, if I want that volume fraction of displaced phase never goes below the specific value (e.g. 0.25) in the domain,what should I do?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] mesh airfoil NACA0012	anand_30	OpenFOAM Meshing & Mesh Conversion	13	March 7, 2022 18:22
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
[blockMesh] Errors during blockMesh meshing	Madeleine P. Vincent	OpenFOAM Meshing & Mesh Conversion	51	May 30, 2016 11:51
interDyMFoam - change in volume fraction	gopala	OpenFOAM Running, Solving & CFD	0	April 27, 2009 11:46
On the damBreak4phaseFine cases	paean	OpenFOAM Running, Solving & CFD	0	November 14, 2008 22:14

All times are GMT -4. The time now is 03:40.