|
[Sponsors] |
November 4, 2014, 02:46 |
outdoor combustion problem
|
#1 |
New Member
hana
Join Date: May 2014
Posts: 23
Rep Power: 11 |
First of all, sorry for poor writing
Now, I am studying non premixed combustion simulation using the fluent. basic boundary condition is like this photo. and Result of pressure contour is like this Basically, residual is not go through under 1e+2. and Velocity contour is also too bad. I don't know how to set the boundary condition of outlet. in real situation, after combustion, outdoor gas is sucking into the reaction zone. But in my case, I just use pressure outlet condition. is there any way to express this type of simulation? again sorry to poor writing |
|
November 4, 2014, 06:54 |
|
#2 |
Member
Join Date: Oct 2011
Posts: 34
Rep Power: 14 |
may be this could help...
|
|
November 4, 2014, 09:46 |
|
#3 |
New Member
hana
Join Date: May 2014
Posts: 23
Rep Power: 11 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |