|November 5, 2014, 11:26||
2D butterfly valve dynamic simulation
Join Date: Nov 2014
Posts: 1Rep Power: 0
I am trying to simulate 2d butterfly valve using Six Degree of Freedom (SDOF) method in fluent. I am encountering error regarding negative cell volume. I have tried to optimize remeshing, smoothing parameters but its not helping. Also the udf is correct (to my knowledge) and zone motion preview is correct. I have used faceted setting for domain deformation, mesh used is unstructured.
Any suggestion on how i can solve negative volume problem???
|dynamic mesh, negative cell volume, sdof|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Dynamic SGS model procedure in Large eddy simulation||mrf6166||Main CFD Forum||39||November 25, 2016 15:13|
|[DesignModeler] mesh only fluid and keep impeller for dynamic simulation||vonkam||ANSYS Meshing & Geometry||4||April 18, 2013 07:47|
|[ICEM] Blocking topology for pipe flow with a butterfly valve||siw||ANSYS Meshing & Geometry||13||November 27, 2012 13:07|
|butterfly valve||euzinho||FLUENT||0||May 28, 2010 08:58|
|Wind Turbine Dynamic Simulation||Michele||FLUENT||2||June 10, 2009 07:14|