|
[Sponsors] |
January 1, 2023, 07:24 |
Emptying a tank simulation through Fluent
|
#1 |
Senior Member
|
Dear All friend,
I have seen two kinds of tutorials for emptying (draining) tank simulation. One is considering pressure outlet at the reservoir end and one with pressure inlet. Which condition works best? I have applied both, but the tank water is not moving a mili meter even. For pressure outlet at the drain side, the backflow volume fraction is 1. In case, if I apply pressure inlet, what about supersonic/initial gauge pressure? by default, everything is zero at the pressure inlet (as per tutorial) .Operating pressure is 101325Pa Regards, SJ |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ANSYS Fluent Sloshing in baffled tank simulation | Fisya | CFD Freelancers | 2 | August 27, 2019 17:55 |
Continuous mixing flow simulation in a Tank | Meca_Ali | FLUENT | 7 | March 14, 2018 05:50 |
Start new Ansys Fluent Simulation automatically | Malue | Fluent UDF and Scheme Programming | 1 | October 4, 2017 01:48 |
Tank sloshing in fluent diverging...need help | lostin4ever | FLUENT | 4 | February 24, 2010 07:20 |
Blow Tank Simulation ... Need Help! | treyevans | CFX | 1 | February 20, 2010 00:42 |