 |
 |
 |
|
|
|
[Sponsors] | ||||
December 16, 2014, 09:56
|
coordinate system
|
#1 |
|
New Member
Join Date: Oct 2014
Posts: 12
Rep Power: 11  |
Hello,
I am trying to simulate an internal flow. When I define the coordinate system in the inlet my results are different from the ones that the coordinate system is in the middle of my system. The geometry is exactly the same. Can the difference in the coordinate system be the reason for this deviation? Thank you very much. 
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Solid-Body kinematics inertial coordinate system | Bollonga | FLUENT | 1 | September 23, 2014 05:46 |
| How can I fix a local coordinate system to the inlet | phys-zephyr | STAR-CCM+ | 3 | May 8, 2014 05:46 |
| coordinate system poroussimplefoam | tehzap | OpenFOAM Pre-Processing | 0 | November 28, 2013 10:40 |
| Creating Coordinate System | ashtonJ | CFX | 0 | February 17, 2011 21:07 |
| Coordinate System | selim | CFX | 1 | October 26, 2007 21:08 |
Linear Mode
