|
[Sponsors] |
February 2, 2015, 16:51 |
DPM evaporated
|
#1 |
New Member
apostolis
Join Date: Oct 2014
Posts: 21
Rep Power: 11 |
hello to everyone,
I' modeling a solid coal combustion and i use species transport model and injection from surface. Also, i use dpm model. At injections, in particle type i have combustion. When i run the solution, at DPM iteration, it shows me "number tacked=3000, escaped=3000, evaporated=0". Is it right? Once i have combustion, i shouldn't have evaporated particles? Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Enthalpy source of Particle in DPM | icemesh | FLUENT | 1 | March 23, 2016 05:19 |
DPM, evaporated droplets do not show up in continues phase | Marnoq | Fluent UDF and Scheme Programming | 0 | January 18, 2015 17:45 |
DPM mass flow | kingpots | FLUENT | 0 | November 29, 2012 22:20 |
DPM injection mass flow rate | kingpots | ANSYS | 0 | November 22, 2012 11:12 |
slow after mesh for enhanced wall treat DPM | joshkemp | FLUENT | 0 | May 1, 2007 17:20 |