|
[Sponsors] |
February 11, 2015, 07:35 |
setup fluent: error convert to polyhedra
|
#1 |
New Member
FC
Join Date: Dec 2014
Posts: 12
Rep Power: 11 |
Hi eveyone,
when I load my mesh in fluent setup a warning occurred: Following mesh operation failed: convert to polyhedra. Please ensure that your current setup is valid. Model information is incompatible with incoming mesh. I've just checked if the named selections were set allright and that's it, so I don't know I to solve it. Does anyone have some suggestion for me? Thank you. |
|
February 11, 2015, 08:45 |
|
#2 |
Senior Member
Cees Haringa
Join Date: May 2013
Location: Delft
Posts: 607
Rep Power: 0 |
Did you change anything in the mesh while checking the named selections, and save the project after that? FLUENT can be quite a ***** when you did so; you can try reloading the mesh, alternatively, go back to the workbench, remove your FLUENT block, and re-hook FLUENT so that it immediatly loads the newest version of the mesh. Typically, this error means FLUENT is expecting a certain mesh that you initially supplied, but because you made changes since, it runs into trouble.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Droplet spreading on two fibers and Fluent VOF | cdf_user | Main CFD Forum | 0 | December 18, 2013 16:24 |
Can't Update FLuent Setup with active Connections in Mesh | dulka90 | FLUENT | 8 | December 9, 2013 11:36 |
Kenics mixer fluent setup | ankur gupta | FLUENT | 0 | August 12, 2010 07:34 |
Polyhedra meshing in Fluent 6.1 | mireis | FLUENT | 1 | August 5, 2010 03:42 |
Fluent 6.3.26 vs 12.1 and partition method | Anorky | FLUENT | 0 | April 27, 2010 10:55 |