|
[Sponsors] |
March 6, 2015, 05:57 |
Pressure drop in VOF PCM simulation
|
#1 |
Member
Rafal
Join Date: Aug 2013
Location: CK
Posts: 36
Rep Power: 12 |
Hello.
I'm trying to simulate the formation of the joint surface in the welding process. I have noticed that, despite the fact that I defined the operating pressure after a few (e.g.,. Two) time steps in the phase in which is the air, pressure falls to negative values. Geometry is shown in the picture - 2D - 1 is the pressure inlet, 2 is pressure outlet (the second one is at the other side). Maybe someone knows why this is happening? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
question regarding LES of pipe flow - pimpleFoam | Dan1788 | OpenFOAM Running, Solving & CFD | 37 | December 26, 2017 14:42 |
Pressure Outlet Guage pressure | Mohsin | FLUENT | 36 | April 29, 2016 17:16 |
Pressure drop not correctly predicted | rks171 | Main CFD Forum | 39 | March 25, 2012 15:11 |
Pressure Drop Calculation | mk_mard | STAR-CCM+ | 3 | August 29, 2011 02:06 |
Hydrostatic pressure in 2-phase flow modeling (long) | DS & HB | Main CFD Forum | 0 | January 8, 2000 15:00 |