|
[Sponsors] |
March 6, 2015, 17:54 |
Vaporization Temperature DPM
|
#1 |
New Member
apostolis
Join Date: Oct 2014
Posts: 21
Rep Power: 11 |
Hi all, iam working on a boiler problem and I am using group injection. My combusting material is coal mv, I am using combusting at material type and the devolatilizing species are mv_vol. The vaporization Temperature of the combusting material is 400K. When I use at injection initial Temperature T=400K, it's all ok, but when I use initial Temperature T=300K I have many problems, such as "Temperature limited to 1 or to 5000K. Is it wrong to have initial Temperature less than Vaporization Temperature?
Thanks in advance, apo |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF for multicomponent particle vaporization | Mohsin | Fluent UDF and Scheme Programming | 17 | January 27, 2021 02:57 |
Static Temperature / Opening Temperature | JulianP | CFX | 12 | April 10, 2019 18:00 |
Enthalpy source of Particle in DPM | icemesh | FLUENT | 1 | March 23, 2016 05:19 |
Inlet won't apply UDF and has temperature at 0K! | tccruise | Fluent UDF and Scheme Programming | 2 | September 14, 2012 06:08 |
Too low temperature at combustor outlet | romekr | FLUENT | 2 | February 6, 2012 10:02 |