mixing plane causes fatal error
Hi everyone!
I received famous and obnoxious fatal error!! (FLUENT received fatal signal) I found out it happens because I use a mixing plane at an axial location! it solved when change "mixing plane geometry" to radial! but my geometry need an axial mixing plane! unfortunately all of my efforts were useless! :confused: so did anybody experience fatal error with this reason!? Is there any solution? Thanks in advance! |
zero angular velocity on stator
Maybe I'm a bit too late...:o
but to work with legacy mixing plane, you have to define angular velocity on both rotor and stator fluid zone... the interface where the fluid is mainly exiting its own domain, should be a pressure outlet, while the other one, where is entering, should be some inlet bc (like pressure-inlet, mass-flow-inlet or velocity-inlet) |
All times are GMT -4. The time now is 04:15. |