 |
 |
 |
|
|
|
[Sponsors] | ||||
March 26, 2015, 08:17
|
Velocity contour at interfaces problem
|
#1 |
|
Member
Anonymous
Join Date: Mar 2014
Posts: 84
Rep Power: 13  |
I have meshed the empty part part separately and the part with obstacles separately. The common faces are defined as interface in fluent and the solution was converged. Now everything is ok but when i generate a velocity contour at mid plane it is showing zero velocity near the interface zone.
Is there anything wrong in what I did or is this is an interpolation done by fluent?? Actual model is 3d but the attached image is contour on mid plane..... 
|
|
|
|
|
|
March 26, 2015, 09:01
|
|
#2 |
|
Member
Anonymous
Join Date: Mar 2014
Posts: 84
Rep Power: 13 |
Sorry, sorted it out!
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Axial Velocity Contour in non-planar bend | omidmd | CFX | 2 | August 4, 2014 13:04 |
| transient case velocity and temperature problem | amr mobarez | Main CFD Forum | 0 | April 28, 2014 19:00 |
| Problem with negative velocity values | Andris | CFX | 23 | September 20, 2012 08:52 |
| Problem with Automatic Default Interfaces | jehan | CFX | 1 | June 15, 2010 10:11 |
| velocity problem | phy | FLUENT | 1 | February 8, 2008 17:12 |
Linear Mode
