|
[Sponsors] |
Difficulties in implementing " Radiative heat flux boundary condition |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 29, 2015, 02:20 |
Difficulties in implementing " Radiative heat flux boundary condition
|
#1 |
New Member
DRAH
Join Date: Dec 2014
Location: N/A
Posts: 3
Rep Power: 11 |
Dear All, Is it possible to use Fluent's radiation models as a local heaiting source for melting of a plymeric material ? If you have any experience/suggestion on laser heating , could you please share your experience/suggestion. Thanks in advance !
Last edited by drah; May 20, 2015 at 01:01. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
wall heat flux boundary condition | elah599 | OpenFOAM Pre-Processing | 2 | November 26, 2016 17:53 |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
Heat flux boundary condition in mixture model for multiphase flow | gaurav4rt | FLUENT | 0 | October 16, 2013 01:52 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |