problems setting up heat transfer between plates - what is wrong with this?
3 Attachment(s)
Hello,
I have two parallel plates and 40 mm distance between them. Air blows at two sides(left and right) of this gap. Plates have higher temperature than the initial air temp. I utilized kw-sst model with boussinesq. I need to observe heat transfer coefficient between air and plates in the end. But strangely when postprocessing, I see heat transfer coefficient contours for a plate in one color(third attachment). what is wrong about it ? note: second attachment shows velocity vectors for middle plane. (y+ is 3,4) |
All times are GMT -4. The time now is 21:38. |