 |
 |
 |
|
|
|
[Sponsors] | ||||
May 11, 2015, 02:53
|
Parameter Output Problem
|
#1 |
|
New Member
Join Date: Dec 2014
Posts: 4
Rep Power: 11  |
Hey everyone,
I analysed a problem using Ansys Fluent and I want to extract some Output Parameter at a specific Point.The problem is when I create the point and compute the parameter(Surface total heat transfer) and save it as a output parameter it disappear in workbench parameter panel.when I go and check the fluent I see that the output parameter is gone.I have the same problem with Iso-surface Parameters too can anyone help me. |
|
|
|
|
 |
| Tags |
| fluent, parameterization |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2 Way FSI Problem | alialibas | CFX | 23 | July 20, 2016 17:59 |
| writing execFlowFunctionObjects | immortality | OpenFOAM Post-Processing | 30 | September 15, 2013 06:16 |
| Force can not converge | colopolo | CFX | 13 | October 4, 2011 22:03 |
| CFX-5.7 MPICH Parallel Problem (Output of Results) | James Date | CFX | 7 | February 15, 2005 16:03 |
| ICEM5 Hexa output problem | Pete | CFX | 9 | September 16, 2004 18:33 |
Linear Mode
