|
[Sponsors] |
June 24, 2015, 09:23 |
Modeling adsorption in Fluent
|
#1 |
New Member
Jules Katharina
Join Date: Apr 2015
Posts: 3
Rep Power: 11 |
Hi everyone,
I'm modeling the adosprtion of NaCl and KCl on solid particles (transient). So far I set up the process in Fluent and wrote an UDF for the adsorption rate. Regarding that I have two questions: First, how do I include the maximum adsorption capacity of my solid. In my case, the species get adsorbed and therefore the mass fraction of the species in the gas decreases. After the maximum adsorption capacity is reached, the mass fraction in the gas should increase again. But this doesn't happen in my case. Is there a way to include that simply in Fluent? The second question is related to the UDF. I'm using the array yi[0] to access the species site fraction on the solid surface. Does anybody know what this array returns specifically? Any help would be gratefully appreciated! Thanks =) |
|
April 16, 2020, 02:56 |
adsorption
|
#2 |
New Member
alireza javadpour
Join Date: Feb 2019
Posts: 9
Rep Power: 7 |
hi can you give me your UDF code, i am so appreciated, thank you very much
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
looking for a smart interface matlab fluent | chary | FLUENT | 24 | June 18, 2021 09:07 |
chemical reaction modeling using FLUENT | wlt_1985 | FLUENT | 6 | April 16, 2014 07:45 |
The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
Problem in using parallel process in fluent 14 | Tleja | FLUENT | 3 | September 13, 2013 10:54 |
Multiphase flow modeling: CFX or FLUENT? | Paul | Main CFD Forum | 8 | January 24, 2012 09:25 |