|
[Sponsors] |
June 26, 2015, 19:21 |
Problem in unit of model
|
#1 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
Hi,
I had designed a turbine based on unit (mm). But when I imported msh file in fluent and I clicked scale grid option until I change unit to (mm). In fact, y max is 1440 mm in my model. But according to the following figure ymax is 1440000 mm. And also, y min is 0, But here is -5.51998e-11. why? On the other hand, Does this problem make solution will not become correct? I am grateful that guide me until this problem is resolved. Thanks, Best, Amir |
|
June 27, 2015, 05:45 |
|
#2 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
Hi,
Can no-one help? I am really grateful that guide me, otherwise I should design again my model Thanks, Best, Amir |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Turbulence model for mixing problem | nileshjrane | OpenFOAM Running, Solving & CFD | 1 | September 7, 2010 17:48 |
Problem in Herschel-Bulkely model | emad | FLUENT | 0 | May 20, 2009 14:20 |
Two phase Eulerian Model Problem | senthil | FLUENT | 5 | May 21, 2003 02:55 |