|
[Sponsors] |
Is there any way to control velocity & loss together at the inlet? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 5, 2015, 05:45 |
Is there any way to control velocity & loss together at the inlet?
|
#1 |
New Member
Mosayeb
Join Date: Jun 2015
Posts: 11
Rep Power: 10 |
Hello all,
Is there any way to control velocity & loss together at the inlet? Or I can either use VELOCITY INLET or INLET VENT? Regards |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
simpleFoam: Non-uniform mesh near inlet & outlet causes incorrect velocity profile? | Zaphod'sSecondHead | OpenFOAM Running, Solving & CFD | 0 | January 28, 2015 06:17 |
How to define a fixed velocity for a given mass flow rate on inlet | mqasimali | FLUENT | 2 | April 12, 2013 18:24 |
How to apply an outlet velocity profile to another inlet? | siw | FLUENT | 4 | April 10, 2013 12:19 |
Steady pipe flow mean velocity higher than inlet velocity | anita | OpenFOAM Running, Solving & CFD | 7 | September 25, 2012 06:35 |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 16:45 |