|
[Sponsors] |
September 1, 2015, 17:46 |
Note: zone-surface
|
#1 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
Hi
When for the second time I import Case and data, I face with the following note, Why? Preparing mesh for display... Note: zone-surface: cannot create surface from sliding interface zone. Creating empty surface. Note: zone-surface: cannot create surface from sliding interface zone. Creating empty surface. Thanks, |
|
September 3, 2015, 09:56 |
|
#2 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
Can no-one guide?
really I need to your guide. |
|
September 3, 2015, 11:31 |
|
#3 |
Senior Member
Amin
Join Date: Oct 2013
Location: Germany
Posts: 397
Rep Power: 14 |
Is it a warning? are you using mesh interface?
|
|
September 3, 2015, 12:13 |
|
#4 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
||
September 3, 2015, 13:14 |
|
#5 |
Senior Member
Amin
Join Date: Oct 2013
Location: Germany
Posts: 397
Rep Power: 14 |
remove all mesh interfaces in fluent, change all boundary conditions that are interface type to another type such as wall or pressure inlet
check your mesh again, Does the error exist yet? |
|
September 3, 2015, 13:25 |
|
#6 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
||
September 3, 2015, 13:28 |
|
#7 |
Senior Member
Amin
Join Date: Oct 2013
Location: Germany
Posts: 397
Rep Power: 14 |
use mesh interface tab in fluent and delete all of them
|
|
September 3, 2015, 19:02 |
|
#8 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
I am simulating a turbine and this turbine have periodic boundary conditions that they are defined as interface.
Periodicity conditions are imposed along the meridional surfaces delimiting the domain and distant 45 deg in the tangential direction. I done the works that you said, please see the following video file and I am grateful that guide me. http://www.4shared.com/video/-PKaGJG...titled_34.html Thanks, Best, Aja |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
[Commercial meshers] star-ccm mesh to O\/F | DLC | OpenFOAM Meshing & Mesh Conversion | 77 | September 19, 2016 09:25 |
laminarNusselt utility | sajad6 | OpenFOAM Programming & Development | 1 | October 24, 2015 16:14 |
[snappyHexMesh] Problem with Sanpper, surface still Rough | Zephiro88 | OpenFOAM Meshing & Mesh Conversion | 7 | November 5, 2014 12:05 |
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 09:28 |