|September 4, 2015, 10:53||
Laminar flow inside a filter holder problem with convergence
Join Date: Oct 2014
Posts: 12Rep Power: 4
I am simulating the flow inside a filter holder. I use mass flow as inlet, pressure outlet as outlet , porous jump for my filter and two symmetries because i simulate the one fourth of my holder.
My flow is laminar (maximum reynolds around 320).
However when i simulate it as laminar I have the warning reverse flow in ...
When I simulate it as turbulence i have no error wanring and my simulation converge.
Do you know why can it be?
Thank you very much in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|CFX Treatment of Laminar and Turbulent Flows||Jade M||CFX||14||June 15, 2016 09:36|
|Laminar Pipe Flow convergence issues||preichl||OpenFOAM Running, Solving & CFD||11||September 22, 2014 21:22|
|convergence problem in 3D steady state, laminar flow in a bath||vajiheh||FLUENT||0||July 10, 2009 12:18|
|Convergence problem in SUPERSONIC FLOW||sridhar||FLUENT||0||July 7, 2007 11:16|
|Problem with Convergence at high flow rates||Syed||CD-adapco||1||April 10, 2007 15:18|