|
[Sponsors] |
September 8, 2015, 13:13 |
How can I monitor just ONE cell?
|
#1 |
Member
thomas
Join Date: Jul 2014
Posts: 50
Rep Power: 11 |
Hello all,
The question´s already asked in the title of this thread: can I monitor just one cell of my computational domain? This, without having to go into DesignModeler/Mesher and artificially separate my actual domain into smaller zones etc. Can I just pick ONE cell within Fluent and monitor it? If yes, how? Thank you very much in advance! |
|
September 8, 2015, 20:35 |
|
#2 |
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,665
Rep Power: 65 |
Can you just create a point monitor at the cell location that you want and use either max/min/average property? Or do you need to access the cell values stored internally in Fluent?
|
|
September 9, 2015, 08:03 |
|
#3 |
Member
thomas
Join Date: Jul 2014
Posts: 50
Rep Power: 11 |
Thanks for your reply.
I need a point monitor for min/max/average. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] refineWallLayer Error | Yuby | OpenFOAM Meshing & Mesh Conversion | 2 | November 11, 2021 11:04 |
Journal file error | magicalmarshmallow | FLUENT | 3 | April 4, 2014 12:25 |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |