|
[Sponsors] |
September 10, 2015, 01:30 |
Fluent Negative Volume Error and Remeshing
|
#1 |
New Member
Terry
Join Date: Aug 2015
Posts: 21
Rep Power: 10 |
Hi all,
I am currently doing an ANSYS Fluent Simulation for a NACA 0012 Airfoil with an AOA of 10Deg. I have included a UDF to allow the airfoil to oscillate in the X-direction. However, I think due to remeshing problems, I tend to get a negative volume error whenever I preview mesh motion. I have set time step to be 0.01s and number of time steps to be 100. Does anyone have any idea what could be wrong? I have attached 2 images below for reference. Thank you and have a nice day. |
|
September 15, 2015, 01:38 |
|
#2 |
Member
Bharat
Join Date: Jul 2011
Location: Delhi, India
Posts: 49
Rep Power: 14 |
Hi Terry
I think you need to mesh it again. moreover i faced the same problem once, please go through the thread for your reference. http://www.cfd-online.com/Forums/ans...h-problem.html P.S- try to divide the area near the airfoil into blocks for grid generation. cheers, bharat
__________________
chapter 3: -crossing the threshold- |
|
|
|