Open Channel Initialization by commands
I am trying to run Fluent guided by commands, but when I try to initialize the solution by the command "/solve/initialize/open-channel-auto-init 19 yes" (19 is the pressure-inlet BC zode ID) but when I do that the solution is different than when I use the GUI. Does someone know how to correct this?
|
I think you need to do a compute-defaults beforehand
Also you can use list-defaults to check and see if your initial conditions make sense. |
Thank you very much! That worked well!
|
All times are GMT -4. The time now is 05:18. |