|
[Sponsors] |
October 21, 2015, 15:05 |
Hyrid Mesh Skew
|
#1 |
New Member
Terry
Join Date: Aug 2015
Posts: 21
Rep Power: 10 |
Hi All,
I am currently doing a simulation with dynamic meshing with a combination of both quad and triangle cells for accuracy. I have applied the UDF for both my object and the surrounding quad mesh so as to allow both of them to move within the triangular mesh as one whole rigid body. However, as time passes, the quad-mesh becomes more and more skewed till the point that I receive "negative cells". From what I observe, the quad-mesh seems to move slower than my airfoil even though the same UDF was applied to both of them. May I know what am I doing wrong? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
basic of mesh refinement | arya | CFX | 4 | June 19, 2007 12:21 |