|
[Sponsors] |
High pressure at the end of compression stroke |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 26, 2015, 11:03 |
High pressure at the end of compression stroke
|
#1 |
New Member
Pawan Meena
Join Date: Aug 2015
Posts: 5
Rep Power: 10 |
I am simulating the compression stroke of a Diesel Engine in ANSYS ICE workbench.As, the piston move upward in the compression stroke, just before the injection the pressure calculated by the simulation is more than the actual pressure corresponding to the experiment.The actual value is about 20bar but from the simulation the pressure is calculated about 80bar.I am not getting, why the pressure is rising so much ??
How to solve this problem ?? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
Error in Two phase (condensation) modeling | adilsyyed | CFX | 15 | June 24, 2015 20:42 |
Waterwheel shaped turbine inside a pipe simulation problem | mshahed91 | CFX | 3 | January 10, 2015 12:19 |
Overflow Error in Multiphase Modelling with Two Continuous Fluids | ashtonJ | CFX | 6 | August 11, 2014 15:32 |
transient simulation of a rotating rectangle | icesniffer | CFX | 1 | August 8, 2009 08:25 |