|December 30, 2015, 02:54||
velocity difference ?
Join Date: Apr 2015
Posts: 32Rep Power: 3
I have been dealing with the air flow in a narrow duct comprised of two thin long plates that have a particular temperature. Id like to observe the heat transfer rate between air and plate. I have good mesh at walls ( 0.2<y+<2) and utilized sst model.
The thing I could not understand is although I set the inlet velocity 5,4 m/s in the boundary conditions tab, when postprocessing I see a region which has a velocity of 6.08 m/s or velocity bigger than 5,4 (you can see in the attached picture)
Id like to see your comments on that. is it possible ?
Note: I initialized as all-zones
|Thread||Thread Starter||Forum||Replies||Last Post|
|In fluent post processing, difference between, x velocity and axial velocity?||padmanathan||FLUENT||3||December 20, 2014 16:13|
|Velocity distribution function sampling issue in DSMC||flotus1||Main CFD Forum||6||December 13, 2014 07:18|
|Unexpected difference between velocity / mass-flow inlet||jpo||FLUENT||8||December 10, 2010 08:20|
|difference of velocity field processed by CFD-POST and Fluent||Jiuan||CFX||3||June 16, 2010 08:23|
|what the result is negatif pressure at inlet||chong chee nan||FLUENT||0||December 29, 2001 06:13|