missing case file in some design points using workbench updates
 

Hi all,

I was using the parameter set -> design points on Ansys workbench 15 to do fluent simulations. I checked the boxes for exported the design points. The updates finished successfully. But when I tried to postprocessing the design point project by opening its corresponding workbench file, the case file is missing. It happens to only some of the design points. Others do have the case file and I can postprocess these successfully.

Does anyone know why and how to solve the missing case file in design point project problem? Please.

I don't want to run each of them individually again.

Thank you.
~ Jen

Hi Does anyone have an explanation or solution to overcome this, have a similar issue.

Thanks!