[nnkd]

Hi all,

Wish to consult on a matter regarding the boundary conditions for temperature for my centrifugal compressor. I am trying to compute the isentropic efficiency of a centrifugal compressor and I have been able to get the pressure work done on the fluid. However, I am unable to get the temperature changes. I have turned on energy model. My current set up is based on a pressure solver. I am using mass flow inlet and a mass flow outlet since I have a target mass flow rate in and out provided to me.
Could someone kindly advise if there are any settings that I need to enable to get the temperature results?

Thank you!
Nic