How to plot pressure coefficent distribution arround a section of the wind blade?

mrswordf1sh · February 18, 2016, 00:37

Hi guys,

I am trying to simulate NREL Phase VI Blade. I want to plot the pressure coefficent distribution graph in some sections of the wind blade. I can see the pressure countours in fluent results but how can I plot it like the attached Figure or how can I get numerical data?

`e` · February 18, 2016, 01:23

Use the XY Plots under Results > Plots to export data (either at nodes or cell centres).

LuckyTran · February 18, 2016, 08:52

If you want to plot pressure coefficient, then define a new variable (make a custom field function or a fancy UDF). Then plot the new field function.

mrswordf1sh · February 18, 2016, 11:22

thanks for the responses

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
dsmcInitialise - dsmcFoam	archymedes	OpenFOAM Pre-Processing	94	July 15, 2016 17:14
Pressure Plot for a Turbine Blade	badger1	STAR-CCM+	0	January 21, 2013 16:43
Wind tunnel of a turbine blade tests.	Jonas Pedro Caumo	CFX	3	April 28, 2007 03:35
wind turbine blade pressure picture	amit	Main CFD Forum	0	December 15, 2005 09:41
Gas pressure question	Dan Moskal	Main CFD Forum	0	October 24, 2002 23:02

February 18, 2016, 01:23		#2
`e` Senior Member Join Date: Mar 2015 Posts: 892 Rep Power: 19	Use the XY Plots under Results > Plots to export data (either at nodes or cell centres).

February 18, 2016, 08:52		#3
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,841 Rep Power: 68	If you want to plot pressure coefficient, then define a new variable (make a custom field function or a fancy UDF). Then plot the new field function.

February 18, 2016, 11:22		#4
mrswordf1sh Member numan Join Date: Sep 2014 Posts: 30 Rep Power: 13	thanks for the responses