y+ problem
1 Attachment(s)
Hello, I had to post this thread again in case some new readers may help.
I have a simulation that consist of two parallel heated wall and blowing air between them. Flow is turbulent and attached picture, you can see the y+ contours on one of two walls. Although y+ value should decrease along x direction as flow gets developed, there is a region that shows an increasing. ( I enclosured in the picture). For this reason I have a heat transfer coefficient distribution that decreases from start point naturally but increases at that region then decreases again after that region. What may cause this region ? I need to get rid of that meanless region. |
All times are GMT -4. The time now is 21:47. |