Hi everyone, My draw is duct with wall thickness . when i draw wall thickness in geo -- CFD Online Discussion Forums

March 6, 2016, 08:09	Hi everyone, My draw is duct with wall thickness . when i draw wall thickness in geo	#1
reslan Member Reslan Technical Join Date: Nov 2015 Posts: 49 Rep Power: 10	Hi everyone, My draw is duct with wall thickness . when i draw wall thickness in geometry (0.1mm) and do mesh the element quality is below o.1 and when i do run i note divergence? But draw with wall thickness (1mm) i don't find this problem why ? mesh is hex Thank you in advance!

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Fluent3DMeshToFoam	simvun	OpenFOAM Meshing & Mesh Conversion	50	January 19, 2020 15:33
wall thickness	Jibran Haider	FLUENT	4	February 3, 2012 22:39
Heat transfer BC at wall- why need wall thickness?	Julie	FLUENT	7	February 3, 2012 21:41
Wall thickness boundary condition	mskim	FLUENT	0	February 14, 2009 16:37
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12

All times are GMT -4. The time now is 15:15.