 |
 |
 |
|
|
|
[Sponsors] | ||||
modelling of open from top continuous sedimentation chamber |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 22, 2016, 06:07
|
modelling of open from top continuous sedimentation chamber
|
#1 |
|
New Member
madhusudan
Join Date: Mar 2016
Posts: 1
Rep Power: 0  |
1. Is.VOF model required?
2. If not then if i gave top wall as symmetry is it true..? 3. at the inlet gate why the velocity is not uniform throughout the section even after giving velocity inlet condition. Ps :At prsent using only single phase model for modelling of fluid,will model sediments after result match. now using K-E turbulence model.... Plz respond fast.. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
| Overflow Error in Multiphase Modelling with Two Continuous Fluids | ashtonJ | CFX | 6 | August 11, 2014 14:32 |
| Modelling of open channel | rkmittal1108@gmail.com | FLUENT | 0 | December 13, 2013 08:52 |
| "parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 11:44 |
| Help modelling a 2D open channel | egge24 | FLUENT | 1 | February 11, 2011 13:03 |
Linear Mode
