 |
 |
 |
|
|
|
[Sponsors] | ||||
Fan rotor - interface and periodic repeats setup |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 4, 2016, 10:08
|
Fan rotor - interface and periodic repeats setup
|
#1 |
|
New Member
Dan Smrcka
Join Date: May 2016
Posts: 1
Rep Power: 0  |
Hello everyone,
I am struggling a bit with an interface setup for a fan rotor. I've meshed a single passage and the duct in ICEM, defined periodicity and exported to Fluent. But when I want to set up the interface, the periodic repeats option to rotate the whole 360 degrees won't do the trick, it seems to expect same number of counterparts of the stator. Keeping this option blank makes only that one part of the interface work, the rest behaves as a wall. Is there any way around this apart from meshing the rotor as one piece? Thanks! |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Help with troubleshooting periodic setup | cfdworks | ANSYS Meshing & Geometry | 0 | March 13, 2014 23:46 |
| [GAMBIT] periodic faces not matching | Aadhavan | ANSYS Meshing & Geometry | 6 | August 31, 2013 11:25 |
| how to setup a periodic numerical model | saleh alsubari | Main CFD Forum | 0 | August 22, 2012 04:45 |
| [ICEM] how to define periodic in icem ? | mingersai | ANSYS Meshing & Geometry | 1 | February 3, 2012 17:46 |
| periodic boundary conditions setup | studentcfd | CFX | 4 | October 25, 2007 01:38 |
Linear Mode
