|
[Sponsors] |
May 17, 2016, 10:18 |
Please HELP: Postprocessing_LES data
|
#1 |
New Member
Kumar
Join Date: Feb 2016
Posts: 23
Rep Power: 10 |
Dear All,
I need some guidance from experts regarding my post processing of LES simulation. I am studying about BL transition phenomenon, for a simple flat plate geometry at a small incidence. I have done simulation with monitor points(lines) and saved data's for every 50time steps. I used Matlab to see the time averaged results. I herewith attached some plots. 1. CF: Skin friction coefficient for monitor points along the inclied plate in different z direction values. I feel the Cf value is bit weird compare to the Blasius solution for laminar and turbulent. Also, it approaches to zero around 0.52m, which I can say is the region of seperation. My question is is the Cf plot is meaningful? How do I conclude with this for transition? 2. Tavg_rms : Here we can see the flow starts fluctuating around 0.45m. so this is the point where it starts to behave has turbulent flow 3. Tavg_rms_x & xvel : RMS x fluctuation & Velocity along X, is plotted against Tangential direction (Y) at different stream wise direction to see the BL growth. How can I conclude by saying that there is transition, which occurs in the region. The shear stress plot behaves as same as CF plot and I cant come to conclusion with shear stress or cf plot. what are all other values would give me a meaningful result to justify the transition phenomenon. I would be more happy if someone could help me out. Looking for your valuable comments. Kind Regards, Kumar |
|
May 23, 2016, 10:22 |
|
#2 |
New Member
Kumar
Join Date: Feb 2016
Posts: 23
Rep Power: 10 |
Hi,
someone could you please help me with the problem I am facing? |
|
Tags |
boundary layer flow, les, transition |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFD by anderson, chp 10.... supersonic flow over flat plate | varunjain89 | Main CFD Forum | 18 | May 11, 2018 08:31 |
[OpenFOAM] Paraview doesn't seem to be picking up data generated by icofoam | MikeHersee | ParaView | 2 | January 6, 2015 09:27 |
Data Produced From Fine Marine Cant Match with The Experimental Data | PeiSan | Fidelity CFD | 4 | August 23, 2014 06:33 |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 11:52 |
How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 18:27 |