 |
 |
 |
|
|
|
[Sponsors] | ||||
May 26, 2016, 13:17
|
DEM setting up
|
#1 |
|
New Member
frank tsai
Join Date: May 2016
Posts: 1
Rep Power: 0  |
Hi,
I am using DEM function in ansys 16.2 for my fluidized bed, and I found the DEM would take a lot of Ram space during calculating n. Is it a normal situation, or I miss something important when I set up the model ? PS: It spends 24G Ram during the calculation and it takes more than an hour to finish a iteration. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Setting Initial volume fraction for the DEM particles | anoopjangra | STAR-CCM+ | 4 | March 26, 2024 07:59 |
| using chemkin | JMDag2004 | OpenFOAM Pre-Processing | 2 | March 8, 2016 23:38 |
| [snappyHexMesh] determining displacement for added points | CFDnewbie147 | OpenFOAM Meshing & Mesh Conversion | 1 | October 22, 2013 10:53 |
| Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 22:58 |
| Warning 097- | AB | Siemens | 6 | November 15, 2004 05:41 |
Linear Mode
