|
[Sponsors] |
Local and Global Co-ordinate system are not Same ! |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 27, 2016, 09:44 |
Local and Global Co-ordinate system are not Same !
|
#1 |
New Member
Samneet Singh Wilkhoo
Join Date: May 2016
Posts: 1
Rep Power: 0 |
I have just started learning Ansys FLuent. To do so, i am following some tutorials from youtube. At one instant, i was needed to make a geometry in design modeller and i created a new plane (YZ ) and offset to along global X axis by -8 inches.
but my Local orientation is not same as global. red=x, blue=z, green=y so, when i did above steps (in italics) to create a plane, my plane was offset along blue axis in local co-ordinates, Why so? also, i created the plane in global YZ. But, i appeared as local XY (parallel to global YZ). Why it is not shown same as that of global YZ ? in other words, why local X is Global Y, local Z is global X and local y is global Z ? why can't local x be global x and so on ? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Micro Scale Pore, icoFoam | gooya_kabir | OpenFOAM Running, Solving & CFD | 2 | November 2, 2013 13:58 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |
Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |