|
[Sponsors] |
May 27, 2016, 10:10 |
Asking for help in studies
|
#1 |
New Member
student
Join Date: May 2016
Posts: 4
Rep Power: 9 |
my task is to simulate the distribution of contamnate concentrations in a room with a pollutant source from the room surfaces (walls, floor and ceiling) can anyone tell me how to add the pollution in the model, how to set values? thank u!
|
|
May 27, 2016, 10:14 |
|
#2 | |
Senior Member
nm
Join Date: Mar 2013
Posts: 100
Rep Power: 13 |
Quote:
If it's traces of contaminant, just inject particles using the DPM model. |
||
May 27, 2016, 11:11 |
|
#3 |
New Member
student
Join Date: May 2016
Posts: 4
Rep Power: 9 |
thank you very much for reply,
Yes, I have the diffusion coefficient of gas. I don't know where I find multi species, help me please. |
|
May 27, 2016, 11:13 |
|
#4 |
Senior Member
nm
Join Date: Mar 2013
Posts: 100
Rep Power: 13 |
||
May 27, 2016, 20:41 |
|
#5 |
New Member
student
Join Date: May 2016
Posts: 4
Rep Power: 9 |
thank you very much for reply,
I introduce the gas, but in boundary conditions I found the Mass fraction, but in our work, I need to introduce a flow from the chamber walls. |
|
May 27, 2016, 20:43 |
|
#6 |
New Member
student
Join Date: May 2016
Posts: 4
Rep Power: 9 |
thank you very much for reply,
I introduce the gas, but in boundary conditions I found the Mass fraction, but in our work, I need to introduce a flux from the chamber walls. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Studies about usage of OF and validation of chtMRSF | hcl734 | OpenFOAM Verification & Validation | 1 | February 11, 2016 05:15 |
Seeking guidance in how to do: Mesh Independence Studies | Jeeloong | Main CFD Forum | 1 | March 6, 2015 14:21 |
Fluent speed up studies | Anna Tian | FLUENT | 13 | February 9, 2014 15:33 |
Parametric Studies Using Fluent 6.1 | Jim | FLUENT | 0 | April 12, 2003 10:22 |
mixing studies | Kai Kang | Main CFD Forum | 1 | July 17, 2000 10:58 |