|
[Sponsors] |
June 22, 2016, 03:09 |
Coarsening a copied face in Fluent?
|
#1 |
Senior Member
Emre G
Join Date: May 2011
Location: Turkey
Posts: 126
Rep Power: 14 |
Hi,
1) Firstly i want to copy a face in fluent , then i will try to coarse this face . But I dont know how to do. Can you help me please? 2) Will this copied coarse face be included in analysis? Because I dont want to include in simulation. I will just use this face as a post process. regards. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Errors during blockMesh meshing | Madeleine P. Vincent | OpenFOAM Meshing & Mesh Conversion | 51 | May 30, 2016 10:51 |
snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 10:58 |
Fluent UDF for Micro Flow Face Slip Velocity | daniel_george_carter | Fluent UDF and Scheme Programming | 0 | May 12, 2013 05:39 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
[Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |