 |
 |
 |
|
|
|
[Sponsors] | ||||
July 21, 2016, 09:04
|
Stationary Fluid Zone Boundary Condition
|
#1 |
|
Senior Member
Onur Özcan
Join Date: Feb 2016
Location: Istanbul/Turkey
Posts: 461
Rep Power: 13  |
Hi all,
I have been working on thermal behaviours of 3D glass mould equipments. Some fluid zones are stationary as I have accepted in that way. I could not find correct BC to define temperature that has had. For example, a fluid zone has 1200celcius and velocity is negligible, wall or velocity inlet BC is like correct? but I am not sure. I have defined velocity inlet BC. (the first image attached) Second image is to be shown as model I have done. How can I enter correct BC inputs? Kind Regards, |
|
|
|
|
|
July 21, 2016, 09:05
|
|
#2 | |
|
Senior Member
Onur Özcan
Join Date: Feb 2016
Location: Istanbul/Turkey
Posts: 461
Rep Power: 13 |
Quote:
|
||
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 10:28 |
| [Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 11:52 |
| Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 01:00 |
Linear Mode
