Stationary Fluid Zone Boundary Condition

oozcan · July 21, 2016, 08:04

Hi all,

I have been working on thermal behaviours of 3D glass mould equipments.

Some fluid zones are stationary as I have accepted in that way. I could not find correct BC to define temperature that has had.

For example, a fluid zone has 1200celcius and velocity is negligible, wall or velocity inlet BC is like correct? but I am not sure. I have defined velocity inlet BC. (the first image attached)

Second image is to be shown as model I have done.

How can I enter correct BC inputs?

Kind Regards,

oozcan · July 21, 2016, 08:05

Quote:

Originally Posted by oozcan

Hi all,

I have been working on thermal behaviours of 3D glass mould equipments.

Some fluid zones are stationary as I have accepted in that way. I could not find correct BC to define temperature that has had.

For example, a fluid zone has 1200celcius and velocity is negligible, wall or velocity inlet BC is like correct? but I am not sure. I have defined velocity inlet BC. (the first image attached)

Second image is to be shown as model I have done.

How can I enter correct BC inputs?

Kind Regards,

Total model is attached.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Wind turbine simulation	Saturn	CFX	58	July 3, 2020 01:13
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam)	cfdonline2mohsen	OpenFOAM	3	October 21, 2013 09:28
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem	Attesz	OpenFOAM Meshing & Mesh Conversion	12	May 2, 2013 10:52
Low Mixing time Problem	Mavier	CFX	5	April 29, 2013 00:00