|
[Sponsors] |
August 15, 2016, 07:40 |
non-complete combustion problem
|
#1 |
Member
Join Date: Mar 2016
Posts: 73
Rep Power: 10 |
Hey,
i have some problems with my combustion simulation. I use the partially premixed model and set the mean mixture fraction of the inlet to the value which produces the highest temperatures. i got this value from the pdf table. the problem is, that the combustion is not complete. the temperature is about 500k too low and there is still oxygen left. i use methane as fuel and air as oxidizer. the mean mixture fraction is at 0.05661896. i hope that you have a clue of what is going wrong sufjanst |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ECFM 3Z combustion problem | Bücherknopf | STAR-CD | 12 | September 15, 2020 04:39 |
Coal Combustion Problem | svsadatia | CFX | 0 | March 7, 2016 04:33 |
Ansys CFX problem: unexpected very high temperatures in premix laminar combustion | faizan_habib7 | CFX | 4 | February 1, 2016 17:00 |
hel (turbulent viscosity ratio limited) for supersonic combustion problem | omar.2002bh | FLUENT | 2 | September 5, 2012 11:04 |
Problem using EDM for combustion | nakul | FLUENT | 1 | August 11, 2011 05:01 |