|
[Sponsors] |
no water saturation in my Fluent fuel cell simulation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 17, 2016, 03:30 |
no water saturation in my Fluent fuel cell simulation
|
#1 |
New Member
Join Date: Jul 2016
Posts: 8
Rep Power: 9 |
Hello,In my simulation, both anode and cathode inlet gas relative humidity are 100%.And current density is around 1 A/cm2.The results show that cathode water saturation is around 0.2 approximately.But anode water saturation is zero.And I tried a lot of times.I need your help.Why is the anode saturation is zero
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[openFuelCell] Fuel Cell Simulation in OpenFOAM | Parisa_Khiabani | OpenFOAM Community Contributions | 41 | January 21, 2020 15:40 |
No liquid water exist in my Fuel Cell simulation | fatchang | FLUENT | 19 | October 15, 2018 14:27 |
Some questions about flow boiling simulation in Fluent | beastieboys6 | FLUENT | 8 | November 20, 2017 23:47 |
The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
simple questions on water in Fluent | me3840 | FLUENT | 6 | November 19, 2010 09:25 |