[PulpCairns]

Hi

I am running a transient internal flow simulation. I would like to keep simulating time steps until the total pressure of the fluid becomes constant (within a tolerance). I do not know how many timesteps will be required before starting the simulation.

Is there a way to implement this in fluent. I have tried looking into the convergence manager and setting up a total volume integral monitor but I can't figure out how to stop a simulation when this becomes constant.

Thanks for any help

[PulpCairns]

This has been solved.

The problem was the stopping criteria was too small and was never met. Noobs mistake really.

[ERA]

How do you setup a stopping criterion to automatically stop the simulation when the stopping criterion is met?