|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: Sep 2016
Posts: 1
Rep Power: 0 ![]() |
hello everyone.
i have trouble in my simulation. i'm trying to confirm whether diffusion is really working in Fluent. so, i set some conditions like below. model : VOF ✔implicit-body-force species-Transport ✔diffusion-enertgy~ ✔full-multicomp~ phase : primary-phase = mixture-template secondary-phase = hydrogen cell-zone-conditions : no change boundary-conditions : no change(no inlet, no outlet) solution-methods : PISO we made patch at solution-initialization in half of the material. so i could get the state that there were hydrogen phase and mixture-template phase in the material.(see figure) and then, i trid to run-calculation. the calculation ran, but there was no change between two phasese. it was same at time 0. so i have not confirmed binary diffusion. please teach me how to confirm binary diffusion. |
|
![]() |
![]() |
![]() |
Tags |
diffusion, fluent, multicomponent diffusion |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error in solution using "Grid Interface" | agustinvo | FLUENT | 4 | January 20, 2015 12:03 |
Constant velocity of the material | Sas | CFX | 15 | July 13, 2010 08:56 |
steady state, laminar vof_model | Garima Chaudhary | FLUENT | 0 | May 24, 2007 03:11 |
Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 08:42 |
About the difference between steady and unsteady problems | Lisa | Main CFD Forum | 11 | July 5, 2000 14:37 |