VOF model

attaullah · October 4, 2016, 10:51

Hi every one.

I am trying to simulate a venturi scrubber AS SHOWN IN FIGURE. In figure you can see that water is injected from the side nozzles. Air from the main inlet. I have set the BC to velocity inlet for water and air but when i tried to set the velocity for air , the momentum tab does not open for setting of velocity as in fig venturi1. Also the multiphase tab does not open for setting of the volume fraction.

Please help me in this regard.

Atta

Bhargavdc · October 5, 2016, 02:06

You have to give mixture velocity and set secondary phase volume fraction as per your requirement.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mixture model + VOF?	blacksoil2012	Fluent Multiphase	2	February 8, 2014 23:59
VOF Model or Mixture Model	mems21	FLUENT	2	March 9, 2010 10:37
A Problem with setting the time step in VOF model	Le	FLUENT	2	July 20, 2006 22:00
free surface of VOF and melting model?	wanghong	FLUENT	3	March 13, 2006 09:57
help needed for vof model	yan	FLUENT	3	December 16, 2005 01:17

October 5, 2016, 02:06		#2
Bhargavdc New Member Gujarat Join Date: Oct 2016 Location: Ahmedabad Posts: 1 Rep Power: 0	You have to give mixture velocity and set secondary phase volume fraction as per your requirement.