Home > Forums > Software User Forums > ANSYS > FLUENT

Pressure Swirl Atomiser

Mark Forums Read

Reply

Search this Thread

October 7, 2016, 06:23	Pressure Swirl Atomiser	#1
Parash New Member Parash Join Date: Oct 2016 Location: United Kingdom Posts: 1 Rep Power: 0	Dear All, I am tyring to model flow inside a pressure swirl atomiser. But I am struggling to define a UDF so as to seperatre the two phases which is the air vacuum which is present inside inside the atomiser and the fuel. Cheers, Parash

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind tunnel Boundary Conditions in Fluent	metmet	FLUENT	6	October 30, 2019 13:23
Periodic flow using Cyclic - comparison with Fluent	nusivares	OpenFOAM Running, Solving & CFD	30	December 12, 2017 06:35
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 07:27
Swirl in Pressure Swirl Atomizer	varunrajendra	FLUENT	0	August 19, 2009 13:09
Swirl in backflow on pressure outlets	Jonas Larsson	FLUENT	17	February 3, 2000 03:14

All times are GMT -4. The time now is 13:52.