|
[Sponsors] |
October 31, 2016, 22:11 |
DPM BC "Reflect" for Pressure Outlet
|
#1 |
New Member
Salman Sakib
Join Date: Aug 2016
Posts: 8
Rep Power: 9 |
Hi I am simulating a wave tank where one side is a velocity inlet and other side is a pressure outlet. But after the DPM injection I set both the BC for the inlet and outlet as "Reflect" in the DPM tab in the BC conditions of each. I wanted to keep the limited particles inside the system though the water flow is like a channel. I'm not sure if it's working.
Does DPM particles leave the system through outlets even though the BC of the outlets are set as "Reflect/Trap"? Thanks a lot in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure Outlet Guage pressure | Mohsin | FLUENT | 36 | April 29, 2016 17:16 |
Pressure Outlet - Effect of domain | bineet_aero | STAR-CCM+ | 3 | April 5, 2016 04:51 |
Boundary conditions outlet | SarahLee | OpenFOAM Running, Solving & CFD | 1 | November 28, 2015 09:34 |
Supersonic outlet working | saisanthoshm88 | CFX | 1 | November 15, 2015 18:43 |
Too low temperature at combustor outlet | romekr | FLUENT | 2 | February 6, 2012 10:02 |