|November 1, 2016, 11:54||
fsi analysis using fluent and boundary condition problem
Join Date: Nov 2016
Posts: 1Rep Power: 0
I'm working on fsi analysis.infact it is modal analysis of a pipe with different flow velocities.I do this by static structural with fluent and system coupling in ansys.the problem is when I want to set up fluent at boundary conditions section in zone there is not the solid pipe's interface that I've determined in static structural.so my setup doesnt complete with only one interface.how can I have two interfaces in this section?
can anyone help me?
|Thread||Thread Starter||Forum||Replies||Last Post|
|FLUENT boundary condition problem with gmsh||EIvb||FLUENT||0||April 30, 2013 07:45|
|problem about periodic boundary condition in Fluent||winnawinna||FLUENT||0||December 29, 2010 00:32|
|asking for Boundary condition in FLUENT||Destry||FLUENT||0||July 27, 2010 00:55|
|How to use a solution as an inlet boundary condition in another problem in fluent||geryes||FLUENT||0||February 25, 2010 17:32|
|Problem with ambit||Lio||FLUENT||4||July 6, 2004 08:23|